However, the second method of outage recording may be considered.In most cases, for smaller LDCs whose budget constraints dont necessarily allow for these increased costs, the look towards finding a solution of using what they already have available to them.With Multispeak, this has become a reality because this protocol will tie together all of the internal systems so that they communicate with each other.
The linking together of systems via Multispeak is the easy part. Sensus Field Logic User Guide How To Set TheThe more difficult part is how to set the priorities on how the various systems get updated if changes are made, and how to prioritize the vast quantities of information available. For the purpose of this paper, we will only focus on the outage management segment of the whole picture. When a meter loses power for less than a configured number of seconds, it is considered a click or momentary outage rather than an outage. However, the ODS needs to be able to export a running total of click counts to the GIS (a 365 day report will be run monthly with 30 day, 60 day and 90 days slices). Using the Power Fail flags, utilities can streamline their outage management processes by having a more accurate picture of which consumers have lost power. In this way the outage team can more quickly analyze the extent of the outages and send resources to the source of each outage. ![]() The data management strategy must define the system of record (SOR), or the source of each component of data which might be used by multiple systems. Some things to consider in the creation of this data management strategy. The programming of GPS coordinates into the AMI meters should not lead the utility to store the location information for the meters in the AMI system. The meter does not have a GPS locator, but rather the coordinates are programmed into the meter upon installation. When meters move, their coordinates are no longer accurate (unless re-programmed), and often the accuracy of the coordinates at the time of programming can be suspect. A utility that may not have ideal data on the location data for meters or even premises, may decide to use the GPS location information within the meter as a starting point for their location information store. The data can be exported from AMI and imported into GIS where the data is maintained and improved over time. As with the location of meters, in the early stages of the data management strategy, the CIS may be considered as the source for the connectivity model; however, ODS systems should be considered the business intelligence system for utilities that have not already purchased software for this purpose. Optimization of the investment in the ODS can include adding business logic to assist in further optimizing other utility-owned systems. If the Connectivity Model can be provided by the GIS to the ODS, the business logic in the ODS can be used to streamline outage management through upstream tracing. This intelligence is normally found in GIS systems, or this might be implemented through an OMS. If the utility owns an OMS, some of the GIS processes cited within this document would simply be replaced by referencing the OMS system. While this document does make reference to thresholds, which by their very nature imply configurability, the effectiveness of this process is clearly improved through receipt of higher percentages of events. To fully optimize the workflow between systems, service order integration using a real time interface should be implemented. Where the workflow is not in real time, changes to this process around timing will need to be considered. CMEP stands for the California Metering Exchange Protocol and is used for transmitting utility metering, billing and administrative information between multiple service providers (MSPs) such as SENSUS, and utilities The MultiSpeak specification is an industry-wide standard for enterprise application interoperability. This standard helps vendors and utilities develop interfaces so that software products from different suppliers can interoperate without requiring the development of extensive custom interfaces.). Real-time information is considered most valuable in the optimization of outage and restoration processes.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |